Cable knife S-484
The knife is designed for cable work during installation and repair of power and supply electrical cables. The knife blade is made of carbon steel, the coating is galvanic, the handle is molded with plastic. The shape of the blade is wedge-shaped, sharpened on one side for the right hand, the shape of the handle is straight with a safety stop. When starting to cut the end of the cable, check for the absence of moisture in the paper insulation and conductors. If necessary, remove existing wet insulation, excess length of ends, areas under sealing caps and cable end grips, as well as those passing through the cheeks of the drums. Defective areas of the cable are cut off with NS sector scissors. Cable cutting begins with determining the installation locations of the bands. At the end of the cable, mark the size of the bandage pad and straighten this section. Next, the resin tape is wound up and a bandage of two or three types of galvanized steel wire is applied manually or using a special device (cutter). The ends of the wire are grabbed with pliers, twisted and bent along the cable.
No reviews found
