METAL RACK STANDART 220/100X60/6

Shelves and racks are compatible in all configuration options, but it is recommended to use shelves and racks of the same series; rib amplifiers are suitable for all types of shelves in the series (Standard, Strong, Hard). Office rack STANDART series (500). - designed for storing documents and various cargo in the office, warehouse, archive, Racks: - racks with a reinforced angular profile of complex section 30x30 mm, - collapsible rack - two types of rack and shelf amplifiers: L-shaped, assembly is carried out using a threaded fasteners (bolts and nuts), and T-shaped, assembly without nuts. (Shelving kits are assembled using bolts, no nuts). Shelves: - Shelf evenly distributed load per shelf 100 kg. - the use of L-shaped amplifiers increases the load on the shelf by 15%, - the use of T-shaped amplifiers increases the load on the shelf by 50%, - the use of shelf rib amplifiers increases the load on the shelf by 60% (it is recommended to start installation from the bottom shelf), - height of the side edge of the shelf – 33 mm, - shelf height adjustment step – 25 mm, Rack: - maximum load on the rack as standard (the upper and lower shelves are attached through L-shaped amplifiers, the remaining shelves directly to the rack) using Standart racks – 500 kg. - the use of an additional set of L-shaped or T-shaped corners on one shelf increases the loading capacity by 10%, - the use of L-shaped reinforcements on all shelves increases the loading capacity by 20%, - the use of T-shaped amplifiers on all shelves increases the loading capacity by 50% . - two types of thrust bearings: plastic support or adjustable metal (when installing adjustable thrust bearings, the load is reduced to 400 kg, increasing the load capacity through the use of amplifiers is not possible), - color: semi-matte gray (RAL 7038), - type of coating: powder. For your safety!!! - A free-standing shelving unit must be screwed to a load-bearing wall. - When using racks with a height of more than 2000 mm, at least three shelves (lower, middle, upper) must be reinforced with L-shaped rack fasteners. - The load on the shelves should be evenly distributed. Load the rack sequentially, starting from the bottom shelf. - It is recommended to use fastening rows of racks to each other. - It is recommended to start installing shelf rib reinforcements from the bottom shelf.